SOLAR INSTALL SAFETY MEASURES

 

Installation of solar panels at your homes is a challenging task and hence we take care to adopt certain safe methods so that nothing goes wrong during the installation process and after its completion.

 

There will be no methods in the module regarding the direction of artificial and concentrated sunlight.

 

"Rated electrical characteristics are within 10 percent of measured value at Standard Test Conditions of: 1000 W/m2, 25°C cell temperature and solar spectral irradiance per ASTM E 892 or irradiation of AM 1.5 spectrum.

 

All the wiring methods shall be following the rules mentioned under the NEC.

 

Under normal conditions, a photovoltaic module may experience conditions that produce more current and/or voltage than reported at Standard Test Conditions. Accordingly,the values of ISC and VOC marked on UL Listed modules should be multiplied by a factor of 1.25 when determining component voltage ratings, conductor capacities, fuse sizes and size of controls connected to the module output.

 

The wind load of the installation site shall be checked beforehand. There will professionals who will check with the buildings of the city and the departments for the requirements.

 

It must be thoroughly checked that the roof of the house is strong enough to support the dead and the live loads that result due to the PV array's installation.

 

Be assured that you are in safe hands when you choose Nippon Energy!